Category: CAD Designs
-
Headrest Mount for Fire Tablet
My son keeps stealing my wife’s phone on long trips. So we needed a sturdy headrest mount that could withstand the punishment of our toddler’s temper tantrums. We purchased 1 at “5 and below” for a Nintendo Switch but it didn’t fit right. I used the base from that to hook it to the headrest.…
-
Change in Camera Design Leads to small Hiccup
So the camera I purchased from Amazon for my new design died shortly after opening it. I bought it a few months ago but didn’t finish printing the new head unit until recently. So returning it was out of the question. I bit the cost, clicked the “purchase again” button and waited for a new…
-
Car Cell Phone Holder from Old Ashtray
I was given this vehicle by my grandfather just before he passed away. It’s a 2004 and was one of the last to feature an ashtray. Great if you smoke but I do not. So I took some measurements and spent a night printing out a descent phone holder that utilizes the ashtray spot as…
-
New Concept for Head Unit Design
I’m not sure if I’m going to run with this design but after doing some research on different shapes and how they’re applied in modern robotics. I decided to mess around with a spherical design for my head unit. This is just a rough concept I hammered out from my existing design. I have a…
-
3D Scanner gets Much Needed Upgrades!
Up until now my 3D scanner used a very cheap $15 webcam for recording images. It’s worked so far for prototyping but I wanted to integrate more methods of scanning into my device. I had already put a lidar sensor on the machine before this upgrade for around $40 at microcenter but now it’s integrated…
-
Battery Monitor and Thermostat Enclosure Panel
I needed an organized project enclosure box for my battery monitor and thermostat controller. If you have an RV, boat etc where you need to keep batteries warm while also keeping tabs on how much battery life you have left this is a cheap and easy solution.This snap-together panel was created for the use Ketotek’s…
-
Keyboard and Mouse Switch
The STL for this print can be found on Thingiverse https://www.thingiverse.com/thing:5710509
-
Custom Junction Boxes for our Home Security System
Our home security system has served us well over the years but because of the apartment we live and the age of the house we’ve had to run the wires on the outside of the walls. I designed these neat clips to fasten the CCTV wiring to the wall but wife soon pointed out that…
-
Cisco Aironet Patch Antenna (AIR-ANT5160NP-R) Wall Mount
https://www.thingiverse.com/thing:5631937
-
CCTV Wire Clips
I created these clips to mount my CCTV cables to the wall. This project was created and designed in millimeters but uses an American 1inch dry wall screw to mount the clips to the wall.Cabling used in this example is: (Five Star Cable RG59 Siamese Coaxial CCTV – Combo 20 AWG)